Zennio Z41 Manual descargar pdf (Pagina 15)

ZENNiO AVANCE Y TECNOLOGÍA _vwww.zennio.com

3.2.1. GENERAL

Each of the configuration options are described below:

Power supply voltage: Select by parameter the voltage of the external power supply

connected to the Z41. The options are 12V, 24V or 29V. This parameter only affects the

management of the internal temperature sensor and has no other purpose.

Internal temperature sensor: Selecting this option allows configuration of the following

parameters related to the Z41’s built-in temperature sensor:

Figure 3.5: Internal temperature sensor parameters

 Sensor calibration: Specify an offset (in tenths of a degree) to compensate for a

fixed deviation between the actual ambient room temperature and that measured by the

Z41.

 Sending period: Select by parameter the time (in tens of seconds) to send cyclically

to the KNX bus the current temperature measurement, via the communication object

"[General] Temperature". The value 0 indicates that periodic sending is disabled.

 Send with a temperature change: The Z41 will send to the KNX bus the current

temperature when it has changed (increased or decreased) with regard to the last

measurement by the amount specified in this parameter (tenths of a degree). To disable

this feature, specify 0 in this field.

Default theme (after programming): Select the default visual theme the Z41 will use

after programming or a reset device. There are 8 themes available, refer to section 3.4.3 for

further details.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 52 53

Sin comentarios

Zennio Z41 Manual Pagina 15